Create a new UDP control block using udp_new (). Bind the block to the local IP address and Port by using udp_bind
STM32 Projects & Tutorials
STM32 microcontrollers are widely used in embedded and industrial systems. This section offers practical tutorials and tested code for STM32F103, STM32F4, and Nucleo boards. Programming is done using STM32CubeIDE with both HAL and LL drivers. Topics include GPIO, UART, ADC, timers, and other core functions—ideal for learners and developers working on real hardware.
STM32 Ethernet #1: Hardware Setup & Ping Test Guide | ControllersTech
Learn how to configure Ethernet on STM32 boards with CubeMX and LWIP. This first tutorial covers hardware setup, pin mapping, PHY address, DMA descriptors, MPU settings, and a successful ping test. Ideal for STM32 F7/H7 users.
How to Setup DMA using Registers
This tutorial of the STM32 Register series will cover how to setup the DMA. We will configure the DMA for the UART peripheral…
How to Setup UART using Registers in STM32
In this tutorial of the STM32 Register series, we will see how to configure the UART using Registers. We will transmit some data via the…
STM32 TIMERS #3. How to use the ENCODER Mode
This tutorial will cover How to use Incremental Encoder with STM32. Also we will see how can we control the angle in Servo motor.
DMA with ADC using Registers in STM32
In this tutorial, we will see how to use DMA in STM32. Here I will use the ADC along with DMA, without any interrupt
STM32 CAN Bus Tutorial: CAN Protocol Communication with Transceivers & Filters
Learn CAN bus protocol in STM32 using CubeMX & HAL. Set up CAN transceivers, filters, interrupts, and communicate between STM32 boards.
This tutorial will cover how to use SPI using Registers in STM32. We will see how can we send and receive data in master mode..
In this tutorial, we will interface the WS2812/B LED with STM32. I am going to use PWM with DMA to send the data to the LED..